Tri-shot manual

Safety & Usage Information

This device is designed for use in controlled airsoft environments only. Improper handling or misuse can result in injury, fire, or legal consequences. Please read the following information carefully before use.

General Warning

The manufacturer and all associated parties accept no liability for injury, damage, or loss arising from:

Misuse of the product
Customisation or modification
Any use that deviates from the product’s original intended purpose.

It is the sole responsibility of the user to ensure the safe and lawful operation of this device at all times.

Prohibited Use

Do not use in public areas, arenas, sports stadiums, or similar locations without proper authorisation.
Do not deploy near people or animals
Do not use it in confined or enclosed spaces.
Do not inhale smoke or fumes emitted by the device

Safe Operation

Outdoor use only.
Only deploy in a clear and open area with a minimum safety radius of 10 metres.
Devices with reduced fuse delay times may detonate within the safety distance — use extreme caution.
Always ensure the device is thrown in a safe direction, away from people, animals, and flammable materials.

Personal Protective Equipment (PPE)

The following PPE must be worn when handling or deploying the device:

Eye protection
Hearing protection
Protective gloves

User Restrictions

Not to be supplied to persons under 18 years of age.

Technical Specifications

Safety Distance: Minimum 10 metres
Maximum Noise Level: Less than 120 dB(A) at 10 metres
Effect: Flash & Bang

Loading Instructions

Follow these steps carefully to ensure the device is loaded safely and correctly. Refer to the diagram for visual guidance.

1. Follow the standard B1 priming guidelines to prepare the device.

2. Insert .209 primer into each of the three chambers (total of 3 primers).

3. Turn the "Lever" away from the "Main Body" to lower the "Tumbler."

4. Rotate the "Tumb" to position number 1 (One Dot).

5. Move the "" back toward the "Main Body" to raise the "Tumbler."

6. Secure the Tri-shot into the B1 device by screwing it in tightly

7. Proceed to deploy the B1 as usual.

Re-Chambering

Following successful deployment of your device, it will need resetting and re-chambering.
Rotate Tri-shot "Lever" away from "Main Body" to lower the "Tumbler"
Rotate the "Tumbler" to the load position (symbolised: ↑)
Insert extended "Loading Tool" (supplied) into the small load hole on the bottom of Tri-shot
Hold device firmly with "Spoon" unobstructed and feed “Loading Tool” through Tri-shot until it makes contact with “Firing Pin” tip.
Push the “Loading Tool” HARD until it stops and hold in place.
Press and hold the “Spoon”, directly over the spring as shown on the B1 instruction diagram.
Remove the “Loading Tool” as the firing pin is now held by the spoon.
Re-insert “Safety Pin”.
Release pressure from spoon and wait for 10 seconds to ensure that the “Firing Pin” is correctly loaded.
After 10 seconds, rotate "Tumbler" to next chamber position (2)
Close "Lever" towards "Main Body" to raise "Tumbler" into position. (this step may be stiff dependant on brand of .209 primer and how they expand during firing)
Deploy device as normal.
Repeat steps 1 through 12 to re-chamber your third and final .209 primer.