C1 Manual

Safety & Usage Information

This device is designed for use in controlled airsoft environments only. Improper handling or misuse can result in injury, fire, or legal consequences. Please read the following information carefully before use.

General Warning

The manufacturer and all associated parties accept no liability for injury, damage, or loss arising from:

Misuse of the product
Customisation or modification
Any use that deviates from the product’s original intended purpose.

It is the sole responsibility of the user to ensure the safe and lawful operation of this device at all times.

Prohibited Use

Do not use in public areas, arenas, sports stadiums, or similar locations without proper authorisation.
Do not deploy near people or animals
Do not use it in confined or enclosed spaces.
Do not inhale smoke or fumes emitted by the device

Safe Operation

Outdoor use only.
Only deploy in a clear and open area with a minimum safety radius of 10 metres.
Devices with reduced fuse delay times may detonate within the safety distance — use extreme caution.
Always ensure the device is thrown in a safe direction, away from people, animals, and flammable materials.

Personal Protective Equipment (PPE)

The following PPE must be worn when handling or deploying the device:

Eye protection
Hearing protection
Protective gloves

User Restrictions

Not to be supplied to persons under 18 years of age.

Technical Specifications

Safety Distance: Minimum 10 metres
Maximum Noise Level: Less than 120 dB(A) at 10 metres
Effect: Flash & Bang

Loading Instructions

Follow these steps carefully to ensure the device is loaded safely and correctly. Refer to the diagram for visual guidance.

Remove the blank holder and place it in a safe location.
Remove the safety pin, allowing the spoon to release and pivot sideways.
Hold the device firmly, ensuring the spoon is unobstructed.
Place the loading tool onto the tip of the firing pin.
Push the loading tool firmly until it stops, and keep it held in place.
Press and hold the spoon directly over the spring, as shown in the diagram.
While maintaining pressure on the spoon, carefully remove the loading tool. The firing pin is now held in position by the spoon.
Reinsert the safety pin.
Release pressure from the spoon and wait approximately 10 seconds to confirm that the firing pin is securely held.
Insert a blank round into the top of the blank holder.
Screw the blank holder back into the grenade body.

Deploying Instructions

Use only in designated, authorised airsoft environments. Ensure all safety guidelines and PPE requirements are followed before deployment.

Grasp the device securely in your hand, holding the spoon firmly against the main body.
Remove the safety pin.
Immediately throw the device in a safe direction*, releasing the spoon.
Move away quickly to a safe distance.
Do not return to the area until the device has fully detonated and it is safe to do so.

*Refer to the Safe Operation section: minimum 10-metre radius in a clear and open area.